[QLab] Motu 828

[Paul Vernon]

Hi,

I use my 828 with Qlab.

You just have to have it patched in. Go to 'sound' in the preferences and
make sure you have a wire from a patch number to your 828 which should be
listed on the right hand side. In the inspector for your cue you select
settings and select the 828 patch then you should have all 8 channels
enabled.

Hope this solves it.


Paul


On 6/10/07 23:19, "Jerry and Marienne" <kreitlow at cmgate.com> wrote:

> I'm embarrassed to bring this up, but desperation can make one bold:
> 
> I've been using v.1.0.3 - the free one - on show for a while now, and
> love it (yes, I know I should upgrade).  Up until now, I've just used
> the built-in stereo output on my Mac iBook G4.  Now, I'd like to
> output through my Motu 828.
> 
> Can I do this?
> 
> Oh, by the way, to submit myself to further embarrassment, I should
> say that load-in is tomorrow. (Show doesn't open until Friday, so
> there's some wiggle room.)
> 
> I've come as far as installing the 828 v.2.5 software, but it tells
> my I have no output or input settings (though it will play alert
> sounds through the 828.  Then when I go to Q Lab, it still only
> outputs through the internal speakers, and I still only have 2 output
> channels in the Master Levels.  The original soundbites are stereo.
> 
> So, is part of it that if the input is only two channels, the output
> will only be two?
> 
> Thanks for your help.
> 
> Jerry Ford
> (320)543-3394
> 
> 
> ________________________________________________________
> WHEN REPLYING, PLEASE QUOTE ONLY WHAT YOU NEED.  Thanks!
> Change your preferences or unsubscribe here:
> http://lists.figure53.com/listinfo.cgi/qlab-figure53.com