[QLab] video cross fades - wha?

[Gareth Jeanne]

 My mistake i have just checked and the TH2G Digital has both digital
(DVI} and analogue (VGA) so you should be able to use standard vga or
convert to RGBHV to send to the projector.  
 However i would reccomend never using S-Video for video output to a
projector, the video quality and reolution from these ports is just
horrible!!  
 Cheers  
 Gareth  
 On Mon, 4 Jun 2007 16:52:43 -0500, Jen Simmons  wrote:   Is it any
different than using the DVI out to one projector?  
   I've done DVI to RGBHV on BNC connectors (preferred) - then which
you can use long rgbhv cables...    or   lower-budget, use the Apple
DVI to S-Video / RCA component video converter... and run either
S-Video or component (rca or coaxial) video to the projectors....   
   ideas / thoughts / what do you do??   I would expect this matrox
breakout box would work the same as a single stream - yes?   
   Jen   
     Jen Simmons   jen at jensimmons   http://jensimmons.com  
http://milkweedmediadesign.com   267-235-6967  skype: jensimmons
   On Jun 4, 2007, at 12:21 pm, Gareth Jeanne wrote:  
 Also you need to be aware that the DVI out is supported only, so you
    
 would only be able to use the digital version, and therfore need to 
   
 either convert to analogue for projectors or sen them DI and use a
DVI     
 splitter, all rather expensive i'm afraid.      
 Gareth Jeanne email:contact at garethjeanne.co.uk Mob:07968 805 114  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.figure53.com/pipermail/qlab-figure53.com/attachments/20070605/c0012a1d/attachment.htm