[QLab] 70s Surround sound...

[Rory Dale]

Ok so I think I understand, but basically I have to fire the same cue  
twice at the same time, and use a fade on the cue I want to bring up  
in another output. There's no way of assigning more than one patch to  
a cue and have control over the fades into those additional outputs?

Thanks,
Rory


On Jan 20, 2007, at 12:36 PM, Matthew Otto wrote:

> I'm not exactly sure if I am reading your post correctly but here is
> how i think you should have it set up. It seems you have the patch
> set up how you want. So lets head directly to programming it.
>
> Create a sound Q (Q1 we shall call it) and in the levels section of
> the inspector set output one to a desired level. In the cross
> pointssection have IN 1 send to the first crosspoint in the first
> row. (Irecomend setting it at a full).
>
> Now add a fade cue for Q1 (we'll call this fade Q1) Which will bring
> input one to -INF, the timing is up to you. Now create a 2nd sound Q.
> (Q2) Make IN 3 at the cross points section correspond to the third
> column in the third row. (IE make them both at full) Then set the 3rd
> Out to -INF.
>
> Now add a 2nd fade Q (Q2 Fade) which will bring Q2 up to the desired
> level.
>
> The final step is to click the cont. check box. This allows for the
> go of Q2 fade to trigger Q2 at the same time. This should work.
> Assuming that the output device is a stereo one.
>
> I have not tired this because I do not have two different output
> devices available right now to test. If anyone else can see that I
> missed a step or it doesn't work please correct it.
>
> Have fun,
> =Matt Otto
> http://mattottosound.com (work in progress)
> please mail off list responses to mottosound at gmail.com
> AIM: ottoman42
>
>
>
>
> On Jan 20, 2007, at 12:40 PM, Rory Dale wrote:
>
>> Hi all,
>>
>> I'm running a quad surround setup, sort of, and I want a cue to start
>> in one set of speakers, so using output device 1 (patch 1?) and then
>> I want to add a fade cue that will fade that running cue into another
>> set of speakers using a separate output device (patch 2?). I can't
>> quite figure out how to do this.
>>
>> Am I missing something simple?
>>
>> Thanks,
>> Rory
>> ________________________________________________________
>> QLab mailing list   (QLab at lists.figure53.com)
>> When replying, please quote only what you need; help us
>> keep the signal/noise ratio of this list high.  Thanks!
>> Change your preferences or unsubscribe here:
>> http://lists.figure53.com/listinfo.cgi/qlab-figure53.com
>
> ________________________________________________________
> QLab mailing list   (QLab at lists.figure53.com)
> When replying, please quote only what you need; help us
> keep the signal/noise ratio of this list high.  Thanks!
> Change your preferences or unsubscribe here:
> http://lists.figure53.com/listinfo.cgi/qlab-figure53.com