[QLab] (no subject)

[Joel Spence]

No, You're right and perhaps I should start over. I just confirmed  
with the guy that loaned me the Emi that, just because its grayed out  
in Audio MIDI Set UP. it doesn't mean its not operating.

So, i think my problem lies in how Qlab is communicating (patching)  
to the device.
And Im a novice on this so, you want to talk about sillyness? here goes:

In the Audio Device Assignment window , how am i able to patch into  
the 6 outs that the Emi 26 has?

The reason why i ask is that no matter where i assign the output  
patches, the signal routes to  the 1st and 2nd outs of the Emi.

OR, am I approaching this wrong?

thanks for your help!

On Feb 26, 2007, at 4:28 PM, Christopher Ashworth wrote:

> You're correct Joel, the free version supports 8 channels in and out.
>
> Correct me if I'm wrong, but it sounds to me like you are describing
> what you are seeing in Audio MIDI Setup, not QLab.
>
> When I hook up my MOTU UltraLite, I also see the channels grayed out
> in Audio MIDI Setup, but that only means that Audio MIDI Setup is not
> allowing me to adjust the device volumes from within that program.  I
> can still use the device from QLab, where all the channels are  
> enabled.
>
> So this may be a silly question, but have you tried the device from
> QLab?
>
> Best,
> Chris
>
> On Feb 26, 2007, at 5:26 PM, Joel Spence wrote:
>
>> Are you sure its a Qlab issue? I thought the basic version included
>> support for 8 channels out and in.
>>
>> On Feb 26, 2007, at 2:07 PM, Rory Dale wrote:
>>
>>> Sounds like you need to buy the Enhanced Audio version of Qlab.
>>>
>>> On Feb 26, 2007, at 4:02 PM, Joel Spence wrote:
>>>
>>>> Im borrowing a Emi 26 for a project to use with Qlab
>>>>
>>>> I've got Tiger 10.4.8 on both my Power G5 and G4 and i've installed
>>>> the correct drivers for this device. This is true for both
>>>> computers:
>>>>
>>>> I've gone into Audio MIDI setup and selected the device's
>>>> properties.
>>>> In the output window, all 6 channels are grayed out. The M is
>>>> available but not the others ..Anyone know the reason for this and
>>>> how i can enable those channels?
>>>>
>>>> thanks!
> ________________________________________________________
> QLab mailing list   (QLab at lists.figure53.com)
> When replying, please quote only what you need; help us
> keep the signal/noise ratio of this list high.  Thanks!
> Change your preferences or unsubscribe here:
> http://lists.figure53.com/listinfo.cgi/qlab-figure53.com